Oroville, Calif.—The DWR updated the progress of the Oroville Dam Spillway repairs Wednesday.
The DWR updated their plan of operation to make sure the main spillway is fully constructed before next winter.
The operation update is awaiting federal approval.
The repair work will continue, and next week will ramp up.
On the main spillway crews will begin prep work to resurface the top layer of the concrete.
Once that work is done a 730 foot section of steel reinforced structural concrete slabs will go in.
There is also resurfacing work being done on the emergency spillway.
Over the next four to six weeks the DWR will do maintenance on three of the six turbines at the Hyatt Powerplant.
Another big factor is the lake level, which is currently at 809 feet just four feet below the main spillway.
Once the lake level reaches 814 feet some water is expected to pass through the gates onto the main spillway.
However the spillway wouldn’t be put to the test unless the water level was to climb to 830 feet.
- Update on Oroville Dam Spillway Work
- Update on Oroville Dam Spillway Construction
- Oroville Dam Spillway Crisis: One Year Later
- Voices of Oroville: One year after Oroville Dam Spillway Crisis
- All, but one Oroville Dam Spillway looting suspect sentenced
- New cracks found in concrete at Oroville Dam Spillway
- Hearing held on Oroville Dam Spillway crisis at state capitol
- Sheriff's Office publishes book documenting the Oroville Dam Spillway Crisis
- Final report on Oroville Dam spillway failure concludes DWR at fault
- Rain may put Oroville Dam's partially repaired spillway to the test